You cannot use Vediamo 5 with Tactrix openport 2.0 because 5 does not support passthru so you need to install Vediamo 4 with openport
Here are the tips on installing and configuring Vediamo with Tactrix openport 2.0 + trendy Agility mode.
Found on the Internet the Vediamo v04.02.02. and Vediamo Data files (password for archives 123) (password for archives 123). It is in this version of Vediamo that Part J is supported, i.e. the ability to connect PassThru devices.
To do this, change the device name (DeviceName) in the slave.ini file (C:\Program Files\Vediamo\Caesar\drivers). Since I already have drivers for OpenPort 2.0 on my laptop and the DAS Xentry program is installed, I just followed the path (C:\ProgramData\Mercedes-Benz\config\Xentry\caesar\driver\slave.ini) and copied from the file slave.ini section “J” data. It turned out like this: DeviceName=“Tactrix Inc. – OpenPort 2.0 J2534 ISO/CAN/VPW/PWM”
After that, on the Vediamo server tab, I pressed UPDATE, unchecked all the checkboxes and left only a checkmark in front of point J.
After all the manipulations, the Vediamo program saw OpenPort 2.0, but refused to connect to the car. It turns out that by default I have the KLine connection type in the Vediamo settings, so I did this: I went to Ecoute, selected the EGS52.CBF file I needed from the Vediamo Data folder, then right-clicked on the line displaying the EGS52-<basisvariante> (KLine 1 OpenPort 2.0 J2534, etc.), clicked on the properties item and changed the connection type from KLine 1 to CANHS1 and got the line EGS52-<basisvariante>(CANHS 1 OpenPort 2.0 J2534, etc.) .
After that, Vediamo connected to the car without any problems and I read my encoding.
